Question:
The first (ΔiH1) and the second (ΔiH) ionization enthalpies (in kJ mol–1) and the (ΔegH) electron gain enthalpy (in kJ mol–1) of a few elements are given below:

Elements Δ_iH1 Δ_iH Δ_egH

I 520 7300 -60

II 419 3051 -48

III 1681 3374 -328

IV 1008 1846 -295

V 2372 5251 +48

VI 738 1451 -40

Which of the above elements is likely to be :

(a) the least reactive element.

(b) the most reactive metal.

(c) the most reactive non-metal.

(d) the least reactive non-metal.

(e) the metal which can form a stable binary halide of the formula MX₂, (X=halogen).

(f) the metal which can form a predominantly stable covalent halide of the formula MX (X=halogen)?

Answer:

(a) Element V is likely to be the least reactive element. This is because it has the highest first ionization enthalpy (ΔiH1) and a positive electron gain enthalpy (ΔegH). It is a noble gas.

(b) Element II is likely to be the most reactive metal as it has the lowest first ionization enthalpy (ΔiH1) and a low negative electron gain enthalpy (ΔegH).The with lowest first ionization enthalpy is likely to be a reactive metal.

(c) Element III is likely to be the most reactive non–metal as it has a high first ionization enthalpy (ΔiH1) but less than the noble gas elements and the highest negative electron gain enthalpy (ΔegH).

(d) Element V is likely to be the least reactive non–metal since it has a very high first ionization enthalpy (ΔiH2) and a positive electron gain enthalpy (ΔegH).

(e) Element VI has a low negative electron gain enthalpy (ΔegH). Thus, it is a metal. Further, it has the lowest second ionization enthalpy (ΔiH2). Hence, it can form a stable binary halide of the formula MX2 (X=halogen).

(f) Element I has low first ionization energy and high second ionization energy. Therefore, it can form a predominantly stable covalent halide of the formula MX (X=halogen).

1
0
0
Report?

Report a problem on Specifications:

Email id:

Comments

< Previous Question

Next Question >

SELECT ex_no,question,question_no,id,chapter FROM question_mgmt as q WHERE courseId='2' AND subId='9' AND ex_no!=0 AND status=1 and id!=1317 ORDER BY views desc, last_viewed_on desc limit 0,10

Popular questions of class 11 Chemistry

The mass of an electron is 9.1 × 10^–31 kg. If its K.E. is 3.0 × 10^–25 J, calculate its wavelength.

Calculate the amount of carbon dioxide that could be produced when

(i) 1 mole of carbon is burnt in air.

(ii) 1 mole of carbon is burnt in 16 g of dioxygen.

(iii) 2 moles of carbon are burnt in 16 g of dioxygen.

Calculate the wavelength of an electron moving with a velocity of 2.05 × 10⁷ ms^–1.

Balance the following redox reactions by ion – electron method :

(a) MnO₄^–(aq) + I^–(aq) → MnO_{2 (s)} + I_2(s) (in basic medium)

(b) MnO₄ ^– (aq) + SO_{2 (g)}→ Mn²⁺ (aq) + HSO₄^– (aq) (in acidic solution)

(d) Cr₂O₇ ^2– + SO_2(g) → Cr³⁺ _(aq) + SO₄^2–(aq) (in acidic solution)

In a process, 701 J of heat is absorbed by a system and 394 J ofwork is done by the system. What is the change in internal energy for the process?

What will be the minimum pressure required to compress 500 dm³ of air at 1 bar to 200 dm³ at 30°C?

In a reaction A + B2 → AB2 Identify the limiting reagent, if any, in the following reaction mixtures.

(i) 300 atoms of A + 200 molecules of B

(ii) 2 mol A + 3 mol B

(iii) 100 atoms of A + 100 molecules of B

(iv) 5 mol A + 2.5 mol B

(v) 2.5 mol A + 5 mol B

At 0°C, the density of a certain oxide of a gas at 2 bar is same as that of dinitrogen at 5 bar. What is the molecular mass of the oxide?

Which one of the following will have largest number of atoms?

(i) 1 g Au (s)

(ii) 1 g Na (s)

(iii) 1 g Li (s)

(iv) 1 g of Cl2(g)

Density of a gas is found to be 5.46 g/dm³ at 27 °C at 2 bar pressure. What will be its density at STP?

SELECT ex_no,question,question_no,id,chapter FROM question_mgmt as q WHERE courseId='2' AND subId='9' AND ex_no!=0 AND status=1 and id!=1317 ORDER BY last_viewed_on desc limit 0,10

Recently Viewed Questions of Class 11 Chemistry

The reaction of cyanamide, NH₂CN (s), with dioxygen was carried out in a bomb calorimeter, and ΔU was found to be –742.7 kJ mol^–1 at 298 K. Calculate enthalpy change for the reaction at 298 K.

NH₂CN(g) + 3/2 O₂(g) → N₂(g) + CO₂(g) + H₂O(l)

What is meant by the conjugate acid-base pair? Find the conjugate acid/base for the following species:

HNO₂, CN^– , HClO₄, F^–, OH^–, CO^2–₃ and S^-

Describe two important uses of each of the following: (i) caustic soda (ii) sodium carbonate (iii) quicklime.

Why is benzene extra ordinarily stable though it contains three doublebonds?

Discuss the consequences of high enthalpy of H-H bond in terms of chemical reactivity of dihydrogen.

Explain the formation of H₂ molecule on the basis of valence bond theory.

A sample of HI_(g) is placed in flask at a pressure of 0.2 atm. At equilibrium the partial pressure of HI_(g) is 0.04 atm. What is K_p for the given equilibrium ?

2HI (g) ↔ H₂ (g) + I₂ (g)

Which hybrid orbitals are used by carbon atoms in the following molecules?

(a)CH₃–CH₃;

(b) CH₃–CH=CH₂;

(d) CH₃-CHO

(e) CH₃COOH

Explain why is sodium less reactive than potassium?

Boric acid is polymeric due to

(a) its acidic nature (b) the presence of hydrogen bonds (c) its monobasic nature (d) its geometry

< Previous Question

Next Question >

Popular questions of class 11 Chemistry

Recently Viewed Questions of Class 11 Chemistry

Comments

Comment(s) on this Question

Important links

Quick Links

Resources

Support

Elements	Δ_iH1	Δ_iH	Δ_egH
I	520	7300	-60
II	419	3051	-48
III	1681	3374	-328
IV	1008	1846	-295
V	2372	5251	+48
VI	738	1451	-40