NCERT Solution
Class 12
Chemistry
The Solid State
a group 14 element is to be converted into n type...

Question:
A group 14 element is to be converted into n-type semiconductor by doping it with a suitable impurity. To which group should this impurity belong?

Answer:

An n-type semiconductor conducts because of the presence of extra electrons. Therefore, a group 14 element can be converted to n-type semiconductor by doping it with a group 15 element.

1
0
0
Report?

Report a problem on Specifications:

Email id:

Comments

Next Question >

SELECT ex_no,question,question_no,id,chapter FROM question_mgmt as q WHERE courseId='3' AND subId='9' AND ex_no!=0 AND status=1 and id!=1769 ORDER BY views desc, last_viewed_on desc limit 0,10

Popular questions of class 12 Chemistry

Give simple chemical tests to distinguish between the following pairs of compounds.

(i) Propanal and Propanone

(ii) Acetophenone and Benzophenone

(iii) Phenol and Benzoic acid

(iv) Benzoic acid and Ethyl benzoate

(v) Pentan-2-one and Pentan-3-one

(vi) Benzaldehyde and Acetophenone

(vii) Ethanal and Propanal

How the following conversions can be carried out?

(i) Propene to propan-1-ol

(ii) Ethanol to but-1-yne

(iii) 1-Bromopropane to 2-bromopropane

(iv) Toluene to benzyl alcohol

(v) Benzene to 4-bromonitrobenzene

(vi) Benzyl alcohol to 2-phenylethanoic acid

(vii) Ethanol to propanenitrile

(viii) Aniline to chlorobenzene

(ix) 2-Chlorobutane to 3, 4-dimethylhexane

(x) 2-Methyl-1-propene to 2-chloro-2-methylpropane

(xi) Ethyl chloride to propanoic acid

(xii) But-1-ene to n-butyliodide

(xiii) 2-Chloropropane to 1-propanol

(xiv) Isopropyl alcohol to iodoform

(xv) Chlorobenzene to p-nitrophenol

(xvi) 2-Bromopropane to 1-bromopropane

(xvii) Chloroethane to butane

(xviii) Benzene to diphenyl

(xix) tert-Butyl bromide to isobutyl bromide

(xx) Aniline to phenylisocyanide

A 5% solution (by mass) of cane sugar in water has freezing point of 271 K. Calculate the freezing point of 5% glucose in water if freezing point of pure water is 273.15 K.

A solution of glucose in water is labelled as 10% w/w, what would be the molality and mole fraction of each component in the solution? If the density of solution is 1.2 g mL^-1, then what shall be the molarity of the solution?

Henry's law constant for CO₂ in water is 1.67 x 10⁸Pa at 298 K. Calculate the quantity of CO₂in 500 mL of soda water when packed under 2.5 atm CO₂pressure at 298 K.

Calculate the mass of a non-volatile solute (molar mass 40 g mol^-1) which should be dissolved in 114 g octane to reduce its vapour pressure to 80%.

The vapour pressure of pure liquids A and B are 450 and 700 mm Hg respectively, at 350 K. Find out the composition of the liquid mixture if total vapour pressure is 600 mm Hg. Also find the composition of the vapour phase.

Calculate the mole fraction of benzene in solution containing 30% by mass in carbon tetrachloride.

How many mL of 0.1 M HCl are required to react completely with 1 g mixture of Na₂CO₃ and NaHCO₃ containing equimolar amounts of both?

If NaCl is doped with 10^-3mol % of SrCl₂, what is the concentration of cation vacancies?

SELECT ex_no,question,question_no,id,chapter FROM question_mgmt as q WHERE courseId='3' AND subId='9' AND ex_no!=0 AND status=1 and id!=1769 ORDER BY last_viewed_on desc limit 0,10

Recently Viewed Questions of Class 12 Chemistry

The following results have been obtained during the kinetic studies of the reaction: 2A + B → C + D

Experiment	A/ mol L^{- 1}	B/ mol L^{- 1}	Initial rate of formation of D/mol L^{- 1} min^{- 1}
I	0.1	0.1	6.0 × 10^{- 3}
II	0.3	0.2	7.2 × 10^{- 2}
III	0.3	0.4	2.88 × 10^{- 1}
IV	0.4	0.1	2.40 × 10^{- 2}

Determine the rate law and the rate constant for the reaction.

How do you explain the amphoteric behaviour of amino acids?

Ferric oxide crystallises in a hexagonal close-packed array of oxide ions with two out of every three octahedral holes occupied by ferric ions. Derive the formula of the ferric oxide.

Vapour pressure of pure acetone and chloroform at 328 K are 741.8 mm Hg and 632.8 mm Hg respectively. Assuming that they form ideal solution over the entire range of composition, plot p_total' p_chloroform' and p_acetoneas a function of x_acetone. The experimental data observed for different compositions of mixture is.

100 ×x_acetone	0	11.8	23.4	36.0	50.8	58.2	64.5	72.1
p_acetone /mm Hg	0	54.9	110.1	202.4	322.7	405.9	454.1	521.1
p_chloroform/mm Hg	632.8	548.1	469.4	359.7	257.7	193.6	161.2	120.7

Action of soap is due to emulsification and micelle formation. Comment.

Name a substance which can be used as an antiseptic as well as disinfectant.

Give the reason for bleaching action of Cl₂.

What are interstitial compounds? Why are such compounds well known for transition metals?

Henry's law constant for CO₂ in water is 1.67 x 10⁸Pa at 298 K. Calculate the quantity of CO₂in 500 mL of soda water when packed under 2.5 atm CO₂pressure at 298 K.

Question:
A group 14 element is to be converted into n-type semiconductor by doping it with a suitable impurity. To which group should this impurity belong?

< Previous Question

Next Question >

Popular questions of class 12 Chemistry

Recently Viewed Questions of Class 12 Chemistry

Comments

Comment(s) on this Question

NCERT Solutions

Quick Links

Resources

Support

Question: A group 14 element is to be converted into n-type semiconductor by doping it with a suitable impurity. To which group should this impurity belong?

< Previous Question

Next Question >

Popular questions of class 12 Chemistry

Recently Viewed Questions of Class 12 Chemistry

Comments

Comment(s) on this Question

NCERT Solutions

Quick Links

Resources

Support

Question:
A group 14 element is to be converted into n-type semiconductor by doping it with a suitable impurity. To which group should this impurity belong?