NCERT Solution
Class 12
Chemistry
The d-and f-Block Elements
compare the general characteristics of the first s...

Question:
Compare the general characteristics of the first series of the transition metals with those of the second and third series metals in the respective vertical columns. Give special emphasis on the following points:

(i) electronic configurations,

(ii) oxidation states,

(iii) ionisation enthalpies, and

(iv) atomic sizes.

Answer:

(i) In the 1^st, 2^nd and 3^rdtransition series, the 3d, 4d and 5dorbitals are respectively filled.

We know that elements in the same vertical column generally have similar electronic configurations.

In the first transition series, two elements show unusual electronic configurations:

Cr(24) = 3d⁵ 4s¹

Cu(29) = 3d¹⁰ 4s¹

Similarly, there are exceptions in the second transition series. These are:

Mo(42) = 4d⁵ 5s¹

Tc(43) = 4d⁶ 5s¹

Ru(44) = 4d⁷ 5s¹

Rh(45) = 4d⁸ 5s¹

Pd(46) = 4d¹⁰ 5s⁰

Ag(47) = 4d¹⁰ 5s¹

There are some exceptions in the third transition series as well. These are:

W(74) = 5d⁴ 6s²

Pt(78) = 5d⁹ 6s¹

Au(79) = 5d¹⁰ 6s¹

As a result of these exceptions, it happens many times that the electronic configurations of the elements present in the same group are dissimilar.

(ii) In each of the three transition series the number of oxidation states shown by the elements is the maximum in the middle and the minimum at the extreme ends.

However, +2 and +3 oxidation states are quite stable for all elements present in the first transition series. All metals present in the first transition series form stable compounds in the +2 and +3 oxidation states. The stability of the +2 and +3 oxidation states decreases in the second and the third transition series, wherein higher oxidation states are more important.

For example are stable complexes, but no such complexes are known for the second and third transition series such as Mo, W, Rh, In. They form complexes in which their oxidation states are high. For example: WCl₆, ReF₇, RuO₄, etc.

(iii) In each of the three transition series, the first ionisation enthalpy increases from left to right. However, there are some exceptions. The first ionisation enthalpies of the third transition series are higher than those of the first and second transition series. This occurs due to the poor shielding effect of 4felectrons in the third transition series.

Certain elements in the second transition series have higher first ionisation enthalpies than elements corresponding to the same vertical column in the first transition series. There are also elements in the 2^nd transition series whose first ionisation enthalpies are lower than those of the elements corresponding to the same vertical column in the 1^st transition series.

(iv) Atomic size generally decreases from left to right across a period. Now, among the three transition series, atomic sizes of the elements in the second transition series are greater than those of the elements corresponding to the same vertical column in the first transition series. However, the atomic sizes of the elements in the third transition series are virtually the same as those of the corresponding members in the second transition series. This is due to lanthanoid contraction.

1
0
0
Report?

Report a problem on Specifications:

Email id:

Comments

< Previous Question

Next Question >

SELECT ex_no,question,question_no,id,chapter FROM question_mgmt as q WHERE courseId='3' AND subId='9' AND ex_no!=0 AND status=1 and id!=2123 ORDER BY views desc, last_viewed_on desc limit 0,10

Popular questions of class 12 Chemistry

Give simple chemical tests to distinguish between the following pairs of compounds.

(i) Propanal and Propanone

(ii) Acetophenone and Benzophenone

(iii) Phenol and Benzoic acid

(iv) Benzoic acid and Ethyl benzoate

(v) Pentan-2-one and Pentan-3-one

(vi) Benzaldehyde and Acetophenone

(vii) Ethanal and Propanal

How the following conversions can be carried out?

(i) Propene to propan-1-ol

(ii) Ethanol to but-1-yne

(iii) 1-Bromopropane to 2-bromopropane

(iv) Toluene to benzyl alcohol

(v) Benzene to 4-bromonitrobenzene

(vi) Benzyl alcohol to 2-phenylethanoic acid

(vii) Ethanol to propanenitrile

(viii) Aniline to chlorobenzene

(ix) 2-Chlorobutane to 3, 4-dimethylhexane

(x) 2-Methyl-1-propene to 2-chloro-2-methylpropane

(xi) Ethyl chloride to propanoic acid

(xii) But-1-ene to n-butyliodide

(xiii) 2-Chloropropane to 1-propanol

(xiv) Isopropyl alcohol to iodoform

(xv) Chlorobenzene to p-nitrophenol

(xvi) 2-Bromopropane to 1-bromopropane

(xvii) Chloroethane to butane

(xviii) Benzene to diphenyl

(xix) tert-Butyl bromide to isobutyl bromide

(xx) Aniline to phenylisocyanide

A 5% solution (by mass) of cane sugar in water has freezing point of 271 K. Calculate the freezing point of 5% glucose in water if freezing point of pure water is 273.15 K.

A solution of glucose in water is labelled as 10% w/w, what would be the molality and mole fraction of each component in the solution? If the density of solution is 1.2 g mL^-1, then what shall be the molarity of the solution?

Henry's law constant for CO₂ in water is 1.67 x 10⁸Pa at 298 K. Calculate the quantity of CO₂in 500 mL of soda water when packed under 2.5 atm CO₂pressure at 298 K.

Calculate the mass of a non-volatile solute (molar mass 40 g mol^-1) which should be dissolved in 114 g octane to reduce its vapour pressure to 80%.

The vapour pressure of pure liquids A and B are 450 and 700 mm Hg respectively, at 350 K. Find out the composition of the liquid mixture if total vapour pressure is 600 mm Hg. Also find the composition of the vapour phase.

Calculate the mole fraction of benzene in solution containing 30% by mass in carbon tetrachloride.

How many mL of 0.1 M HCl are required to react completely with 1 g mixture of Na₂CO₃ and NaHCO₃ containing equimolar amounts of both?

If NaCl is doped with 10^-3mol % of SrCl₂, what is the concentration of cation vacancies?

SELECT ex_no,question,question_no,id,chapter FROM question_mgmt as q WHERE courseId='3' AND subId='9' AND ex_no!=0 AND status=1 and id!=2123 ORDER BY last_viewed_on desc limit 0,10

Recently Viewed Questions of Class 12 Chemistry

The following results have been obtained during the kinetic studies of the reaction: 2A + B → C + D

Experiment	A/ mol L^{- 1}	B/ mol L^{- 1}	Initial rate of formation of D/mol L^{- 1} min^{- 1}
I	0.1	0.1	6.0 × 10^{- 3}
II	0.3	0.2	7.2 × 10^{- 2}
III	0.3	0.4	2.88 × 10^{- 1}
IV	0.4	0.1	2.40 × 10^{- 2}

Determine the rate law and the rate constant for the reaction.

How do you explain the amphoteric behaviour of amino acids?

Ferric oxide crystallises in a hexagonal close-packed array of oxide ions with two out of every three octahedral holes occupied by ferric ions. Derive the formula of the ferric oxide.

Vapour pressure of pure acetone and chloroform at 328 K are 741.8 mm Hg and 632.8 mm Hg respectively. Assuming that they form ideal solution over the entire range of composition, plot p_total' p_chloroform' and p_acetoneas a function of x_acetone. The experimental data observed for different compositions of mixture is.

100 ×x_acetone	0	11.8	23.4	36.0	50.8	58.2	64.5	72.1
p_acetone /mm Hg	0	54.9	110.1	202.4	322.7	405.9	454.1	521.1
p_chloroform/mm Hg	632.8	548.1	469.4	359.7	257.7	193.6	161.2	120.7

Action of soap is due to emulsification and micelle formation. Comment.

Name a substance which can be used as an antiseptic as well as disinfectant.

Give the reason for bleaching action of Cl₂.

What are interstitial compounds? Why are such compounds well known for transition metals?

Henry's law constant for CO₂ in water is 1.67 x 10⁸Pa at 298 K. Calculate the quantity of CO₂in 500 mL of soda water when packed under 2.5 atm CO₂pressure at 298 K.

< Previous Question

Next Question >

Popular questions of class 12 Chemistry

Recently Viewed Questions of Class 12 Chemistry

Comments

Comment(s) on this Question

NCERT Solutions

Quick Links

Resources

Support