Due to economic reasons, only the upper | Class 12 Physics Chapter Communication Systems Physics, Communication Systems Physics NCERT Solutions

For an amplitude modulated wave, the maximum amplitude is found to be 10 V while the minimum amplitude is found to be 2 V. Determine the modulation index μ. What would be the value of μ if the minimum amplitude is zero volt?

A carrier wave of peak voltage 12 V is used to transmit a message signal. What should be the peak voltage of the modulating signal in order to have a modulation index of 75%?

Is it necessary for a transmitting antenna to be at the same height as that of the receiving antenna for line-of-sight communication? A TV transmitting antenna is 81m tall. How much service area can it cover if the receiving antenna is at the ground level?

Which of the following frequencies will be suitable for beyond the horizon communication using sky waves?
(a) 10 kHz
(b) 10 MHz
(c) 1 GHz
(d) 1000 GHz

Digital signals

(i) Do not provide a continuous set of values,

(ii) Represent values as discrete steps,

(iii) Can utilize binary system, and

(iv) Can utilize decimal as well as binary systems.

Which of the above statements are true?

(a) (i) and (ii) only

(b) (ii) and (iii) only

(c) (i), (ii) and (iii) but not (iv)

(d) All of (i), (ii), (iii) and (iv).

Frequencies in the UHF range normally propagate by means of

(a) Ground waves.

(b) Sky waves.

(c) Surface waves.

(d) Space waves.

A modulating signal is a square wave, as shown in Fig. 15.14.

The carrier wave is given by

(i) Sketch the amplitude modulated waveform

(ii) What is the modulation index?

What is the force between two small charged spheres having charges of 2 x 10^-7 C and 3 x 10^-7 C placed 30 cm apart in air?

An infinite line charge produces a field of 9 × 10⁴ N/C at a distance of 2 cm. Calculate the linear charge density.

A polythene piece rubbed with wool is found to have a negative charge of 3 × 10⁻⁷ C.

(a) Estimate the number of electrons transferred (from which to which?)

(b) Is there a transfer of mass from wool to polythene?

A 600 pF capacitor is charged by a 200 V supply. It is then disconnected from the supply and is connected to another uncharged 600 pF capacitor. How much electrostatic energy is lost in the process?

A parallel plate capacitor with air between the plates has a capacitance of 8 pF (1pF = 10^-12 F). What will be the capacitance if the distance between the plates is reduced by half, and the space between them is filled with a substance of dielectric constant 6?

A regular hexagon of side 10 cm has a charge 5 µC at each of its vertices. Calculate the potential at the centre of the hexagon.

A point charge +10 μC is a distance 5 cm directly above the centre of a square of side 10 cm, as shown in Fig. 1.34. What is the magnitude of the electric flux through the square? (Hint: Think of the square as one face of a cube with edge 10 cm.)

A conducting sphere of radius 10 cm has an unknown charge. If the electric field 20 cm from the centre of the sphere is 1.5 × 10³ N/C and points radially inward, what is the net charge on the sphere?

A point charge of 2.0 μC is at the centre of a cubic Gaussian surface 9.0 cm on edge. What is the net electric flux through the surface?

A 12.5 eV electron beam is used to bombard gaseous hydrogen at room temperature. What series of wavelengths will be emitted?

A short bar magnet has a magnetic moment of 0.48 J T^-1. Give the direction and magnitude of the magnetic field produced by the magnet at a distance of 10 cm from the centre of the magnet on (a) the axis, (b) the equatorial lines (normal bisector) of the magnet.

If the bar magnet in exercise 5.13 is turned around by 180º, wherewill the new null points be located?

In a chamber, a uniform magnetic field of 6.5 G (1 G = 10^-4 T) is maintained. An electron is shot into the field with a speed of 4.8 x 10⁶ m s^-1 normal to the field. Explain why the path of the electron is a circle. Determine the radius of the circular orbit. (e = 1.6 x 10^-19 C, m_e= 9.1 x 10^-31 kg)

In a Young’s double-slit experiment, the slits are separated by 0.28 mm and the screen is placed 1.4 m away. The distance between the central bright fringe and the fourth bright fringe is measured to be 1.2 cm. Determine the wavelength of light used in the experiment.

The number density of free electrons in a copper conductor estimated in Example 3.1 is 8.5 x 10²⁸ m^-3. How long does an electron take to drift from one end of a wire 3.0 m long to its other end? The area of cross-section of the wire is 2.0 x 10^-6 m² and it is carrying a current of 3.0 A.

An electric dipole with dipole moment 4 × 10⁻⁹ C m is aligned at 30° with the direction of a uniform electric field of magnitude 5 × 10⁴N C⁻¹. Calculate the magnitude of the torque acting on the dipole.

A storage battery of emf 8.0 V and internal resistance 0.5 Ω is being charged by a 120 V dc supply using a series resistor of 15.5 Ω. What is the terminal voltage of the battery during charging? What is the purpose of having a series resistor in the charging circuit?

A negligibly small current is passed through a wire of length 15 m and uniform cross-section 6.0 x 10^-7 m², and its resistance is measured to be 5.0 Ω. What is the resistivity of the material at the temperature of the experiment?

Two long and parallel straight wires A and B carrying currents of 8.0 A and 5.0 A in the same direction are separated by a distance of 4.0 cm. Estimate the force on a 10 cm section of wire A.