Refer to the periodic table given in you | Class 11 Chemistry Chapter Redox Reactions, Redox Reactions NCERT Solutions

The mass of an electron is 9.1 × 10^–31 kg. If its K.E. is 3.0 × 10^–25 J, calculate its wavelength.

Calculate the amount of carbon dioxide that could be produced when

(i) 1 mole of carbon is burnt in air.

(ii) 1 mole of carbon is burnt in 16 g of dioxygen.

(iii) 2 moles of carbon are burnt in 16 g of dioxygen.

Calculate the wavelength of an electron moving with a velocity of 2.05 × 10⁷ ms^–1.

Balance the following redox reactions by ion – electron method :

(a) MnO₄ ^– (aq) + I ^– (aq) → MnO_{2 (s)} + I_2(s) (in basic medium)

(b) MnO₄ ^– (aq) + SO_{2 (g)} → Mn²⁺ (aq) + HSO₄^– (aq) (in acidic solution)

(c) H₂O_{2 (aq)} + Fe ²⁺ (aq) → Fe³⁺ (aq) + H₂O (l) (in acidic solution)

(d) Cr₂O₇ ^2– + SO_2(g) → Cr³⁺ _(aq) + SO₄^2– (aq) (in acidic solution)

In a process, 701 J of heat is absorbed by a system and 394 J ofwork is done by the system. What is the change in internal energy for the process?

What will be the minimum pressure required to compress 500 dm³ of air at 1 bar to 200 dm³ at 30°C?

In a reaction A + B2 → AB2 Identify the limiting reagent, if any, in the following reaction mixtures.

(i) 300 atoms of A + 200 molecules of B

(ii) 2 mol A + 3 mol B

(iii) 100 atoms of A + 100 molecules of B

(iv) 5 mol A + 2.5 mol B

(v) 2.5 mol A + 5 mol B

At 0°C, the density of a certain oxide of a gas at 2 bar is same as that of dinitrogen at 5 bar. What is the molecular mass of the oxide?

Which one of the following will have largest number of atoms?

(i) 1 g Au (s)

(ii) 1 g Na (s)

(iii) 1 g Li (s)

(iv) 1 g of Cl2(g)

Density of a gas is found to be 5.46 g/dm³ at 27 °C at 2 bar pressure. What will be its density at STP?

A liquid is in equilibrium with its vapour in a sealed container at a fixed temperature. The volume of the container is suddenly increased.
a) What is the initial effect of the change on vapour pressure?
b) How do rates of evaporation and condensation change initially?
c) What happens when equilibrium is restored finally and what will be the final vapour pressure?

Apart from tetrahedral geometry, another possible geometry for CH₄ is square planar with the four H atoms at the corners of the square and the C atom at its centre. Explain why CH₄ is not square planar?

Assuming complete dissociation, calculate the pH of the following solutions:

(a) 0.003 M HCl

(b) 0.005 M NaOH

(c) 0.002 M HBr

(d) 0.002 M KOH

Calculate the enthalpy change for the process

CCl₄(g) → C(g) + 4 Cl(g)

and calculate bond enthalpy of C – Cl in CCl₄(g).

Δ_vapH⁰(CCl₄) = 30.5 kJ mol^–1.

Δ_fH⁰ (CCl₄) = –135.5 kJ mol^–1.

Δ_aH⁰ (C) = 715.0 kJ mol^–1 , where Δ_aH⁰ is enthalpy of atomisation

Δ_aH⁰ (Cl₂) = 242 kJ mol^–1

A sample of drinking water was found to be severely contaminated with chloroform, CHCl₃, supposed to be carcinogenic in nature. The level of contamination was 15 ppm (by mass).

(i) Express this in percent by mass.

(ii) Determine the molality of chloroform in the water sample.

Rationalise the given statements and give chemical reactions :

(i) Lead(II) chloride reacts with Cl₂ to give PbCl₄.

(ii) Lead(IV) chloride is highly unstable towards heat.

(iii) Lead is known not to form an iodide, PbI₄.

Bromine monochloride, BrCl decomposes into bromine and chlorine and reaches the equilibrium:

2BrCl (g) ↔ Br₂ (g) + Cl₂ (g) for which K_c= 32 at 500 K.

If initially pure BrCl is present at a concentration of 3.3 × 10^–3 mol L^–1, what is its molar concentration in the mixture at equilibrium?

Calculate the mass percent of different elements present in sodium sulphate (Na₂SO₄).

For the following bond cleavages, use curved-arrows to show the electron flow and classify each as homolysis or heterolysis. Identify reactive intermediate produced as free radical, carbocation and carbanion.

Write the important conditions required for the linear combination of atomic orbitals to form molecular orbitals.